Mini Drill press, Precision Benchtop Drill Press, Watchmaker Tools Multifunction Precision Bench Crown Punch Remove Broken Screws from Movement Plate

High precision watch repair bench drill, miniature bench drill, adaptable to 110-220V voltage, adopting Taiwan-made ER11 precision collet. XY axis cross slide, can be fine-tuned, the error is only 0.01u, slide travel 13mm, suitable for all kinds of small parts on the watch, drilling accurately without offset. The overall table vise is made of high hardness brass. The left side is made of hard steel. The left side 0.2-1.2 holes can clamp different kinds of minute, second, hour hand needle tube. also can fasten some minute wheel tubes. and clamp some small parts for punching operation. It can also be clamped on various kinds of extendes or sprung watch crown and for operation.The design is very practical. The 3, 5 and 7 holes on the right side can hold different sized watch crown. and hold the the end diameter is 3mm-4mm drill bit . Vise hole can be clamped range: 0.2/0.3/0.35/0.4/0.45/0.5/0.55/0.6/0.65/0.7/0.75/0.8/0.85/0.9mm Packing List: Mini drill press✖️1 Power cord✖️1 One box of 0.3-1.2mm drill bits 0.75mm short drill bits✖️2 Er11 wrench✖️1 Open end wrench✖️1 Allen Wrench ✖️1 Spare belt ✖️1

• High-precision fixed-spindle watch repair bench drill with a chuck diameter of 3.175 mm. If other chuck sizes are required, the ER11 inner sleeve chuck must be replaced.Adaptable to 110-220V voltage, adopting Taiwan-made ER11 precision collet
• XY axis cross slide, can be fine-tuned, the error is only 0.01u, slide total xtravel 13mm, suitable for all kinds of small parts on the watch, drilling accurately without offse
• The overall table vise is made of high hardness brass. The left side is made of hard steel. The left side 0.2-1.2 holes can clamp different kinds of minute, second, hour hand needle tube. also can fasten some minute wheel tubes. and clamp some small parts for punching operation. It can also be clamped on various kinds of extendes or sprung watch crown and for operation.The design is very practical
• The 3, 5 and 7 holes on the right side can hold different sized watch crown. and hold the the end diameter is 3mm-4mm drill bit
• Dimension range of round holes in vise: 0.2/0.3/0.35/0.4/0.45/0.5/0.55/0.6/0.65/0.7/0.75/0.8/0.85/0.9mm